Community Table: First Bents Go Up
Lots of visible progress on the Community Table today. We installed the first four bents and beams to tie them together. Note: A bent is a section on wall
Getting organized for the day. The bents are laid out on saw horses on the right side of the building. The beams are on the left. |
Raising a bent. |
The bent vertical so the tenon can drop into the mortise. If it goes in at angle the tenon could snap. |
Getting a mechanical assist to install a beam |
Using the commander to hammer a beam into place. |
So we were told to initial pieces we worked on. |
Glad this one fit correctly. |
Comments